![]() |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
![]() ![]() ![]() ![]() ![]() ![]() |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
![]() |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Welcome to
|
|
|||||||||||
![]() |
![]() |
![]() |
![]() |
![]() |
|||||||
![]() |
![]() |
![]() |
![]() |
![]() |
|||||||
Roll your cursor over a picture in enlarge on the slide show. | |||||||||||
See More New Products & Product Stories! |
______________________________________________________________________________________________
New Fracking Regulations
Demands Frac Caps and PlugsDesigned to eliminate spillage while transporting your hoses. Our FRAC CAPS & PLUGS easily thread on the male or female FRAC HOSE ends. Available in 4”, 6” and 8” sizes in either Soft and Pliable or Hard Heavy Duty vinyl threaded constructions.
______________________________________________________________________________________________
Powertrack International has invested in the FP175 Finn Power Crimping Machines to further our capability to crimp large bore oilfield and gas drilling hoses and hydraulic hose assemblies. We believe that the additional ability to crimp these large bore oil and gas hose will assist energy exploration companies in the extraction and production of crude oil and natural gases.
______________________________________________________________________________________________
Click Here for Single Weave Dimensions.
Click Here for Dimensions. |
Powertrack International’s “Integral Figure 1502 Union Fittings”, has eliminated 2 leak points per hose and the added expense of x-ray’ing weld points, on Powertrack’s 2”- 5000psi Kelly Hose and Mud Pump Hoses. The “Integral Union Fittings” are manufactured with the high pressure hammer union and the high pressure hose barb combined from one solid piece of metal. This becomes particularly useful on drilling platforms in the ocean or on land based rigs where hose leak points are a concern. The common practice was, historically, to weld a hammer union to the standard API male fitting. The connection is then x-ray’d to insure that the joint is properly fused. Clearly, the benefits provided by this new innovation will be seen by increased time saving and productivity, an overall lower product cost as well as a much “GREENER” solution—no spills! |
![]() |
![]() |
Have a question? Contact us!
888-475-5988